In Figure 4 , the first elongation products with EVA FOAM MANUFACTURER increase in the amount decreases and then increases . The reason is: when the small amount of EVA FOAM MANUFACTURER , EVA FOAM MANUFACTURER DCP decomposition rate and the crosslinking rate to adapt, the elongation products of EVA FOAM MANUFACTURER = 11 or so large ; with an increased amount of EVA FOAM MANUFACTURER.

the decomposition rate is also increased, the gas in the melt is not sufficiently expanded , so the products of the toughness reduced, but because it is not the full expansion of the gas on the product of the skin can not be ignored , even more than the above-mentioned factors, and thus increase the performance of the toughness , so when the amount of EVA FOAM MANUFACTURER more than 15 parts by weight, elongation at break increases. Figure 5 shows that , with the increasing amount of EVA FOAM MANUFACTURER , the tensile strength tended to increase , there is a reason for this phenomenon : In this interval EVA FOAM MANUFACTURER decomposition rate and the DCP adapt crosslinking rate therefore, the apparent overall density of the smallest products , but this time the crust a great influence on the tensile strength , but to make the tensile strength increased. Taking into account the apparent overall density products , tensile strength and elongation of three factors (Figure 6 ), EVA FOAM MANUFACTURER 11 parts take appropriate.

2.3 molding time and temperature on the EVA FOAM MANUFEVA FOAM MANUFACTURERTURER EVA foam manufEVA foam manufacturerturer impact